Latest from the Blog
3/28/2020 – 40 Minutes Install the wire for the trim servo with grommets and edge protection before riveting the skins.Wire to protrude at both ends by approximately 200mm or 8 inches. Install edge protection around the lighteninghole where electrical wire passes through. I don’t have any edge protection on hand so I need to orderContinue reading “Empennage Horizontal Stabilizer Assembly Step 8”
March 28, 2020 – 2 Hours I’m going to combine steps 4-7 because each step is a single rib. It just makes sense to do all the ribs in the same step. In this step is to cleco and rivet Nose rib 6, nose rib 7, Horizontal Stabilizer rib 1, horizontal rib 2, Horizontal ribContinue reading “Empennage Horizontal Stabilizer Assembly Step 4-7”
March 17, 2020 1:15 Minutes Cleco and rivet the Horizontal Stabilizer center channel, rear spar channel, rear spar stuffing plate, and hinge bracket 1. Do not rivet these 12 holes, 6 per side. I have marked them with a black sharpie DNR for “do not rivet”. There are two different size rivets on this step.Continue reading “Empennage Horizontal Stabilizer Assembly Step 3”
Get new content delivered directly to your inbox.